Products & applications
The supply scope
Fabrication and structural construction · Appliances, kitchenware and general manufacturing · Industrial piping and process equipment · Downstream rolling, forming and machining
Flat steel
Hot-rolled coils, sheets and heavy plates for fabrication; cold-rolled material where surface and dimensional control matter. Galvanized, aluminium-zinc coated and prepainted products require a defined substrate, coating and finish. Electrical steel enquiries should specify grain orientation and the required magnetic performance.
Long products
Reinforcing bars, wire rod, merchant bars, beams, channels, angles and other structural sections. Specify the governing standard and grade, section dimensions, length and any fabrication or weldability requirements.
Pipes and tubes
Seamless and welded carbon or stainless pipe and tube, including ERW, LSAW and SSAW enquiries. Manufacturing route, outside diameter, wall thickness, length, end preparation and service conditions belong in the same specification.
Fittings and flanges
Elbows, tees, reducers, caps and flanges for piping systems. Match material, connection type, dimensions and pressure designation to the piping specification; a material grade alone does not define a complete fitting.
Semi-finished steel
Billets, blooms and slabs for downstream rolling and forging. Chemistry, cross-section, length, surface condition and end-use requirements guide mill selection.
Stainless products
Coils, sheets, plates, strip, circles, bars and tubular products. Austenitic grades such as 304/304L and 316/316L, and duplex enquiries, are reviewed against the required standard and service. Define grade separately from finish: 2B, BA, No.1, brushed and decorative surfaces serve different requirements. Forming, welding, corrosion exposure and final polishing should inform selection.